IPX5:4 DSP power amplifier, install
IPX5:4
COMPACT POWER. FULL CONTROL.
A networked install amplifier delivering 4 x 1250 W with OMNEO/Dante audio and FIR-Drive processing.
IPX5:4 DSP power amplifier, install
A 4-channel install DSP power amplifier rated 4 x 1250 W, with 96 kHz FIR Drive processing and OCA/Dante networking.
Get four channels of clean install power without the rack penalty. The IPX5:4 delivers 1250 W per channel, switches each output to Low-Z or 70/100/140/200 V direct drive, and carries 48/96 kHz audio over OMNEO/Dante. FIR-Drive linear-phase filtering, peak and RMS limiters, and impedance load monitoring sit on every output. Signal latency holds at 0.70 ms. Retail, hospitality, worship, mid-size venue — distributed sound that needs real processing in one rack space.
Key features
Four channels, one rack space
1250 W per channel for distributed and foreground sound.
Constant-voltage ready
70/100/140/200 V direct drive per channel, plus Low-Z operation.
Network-native audio
48/96 kHz over OMNEO/Dante on redundant PRIMARY/SECONDARY links.
Linear-phase loudspeaker control
FIR-Drive up to 1025 taps with per-channel limiters.
Protect the install
pilot-tone supervision and impedance monitoring catch a fault automatically.
Cut the standby draw
standby mode keeps the draw under 15 W.
Short introduction
IPX Series Amplifiers
Complete the System
Where this unit fits, and what it pairs with.
Features
Networked install power with the processing on board. The IPX5:4 drives 4 channels 1250 W simultaneously, with a native 96 kHz DSP, FIR Drive up to 1025 taps, and Dante/OCA over OMNEO with fallback for redundancy. Class D output and ecoRAIL keep efficiency high and running costs down, while load monitoring and pilot-tone supervision watch every line. Two rack units. Stadiums, houses of worship, retail, transport hubs, and multi-zone installs that route and process from the amplifier itself.
- Multichannel power: 4 channels at 1250W/4 Ohms, 70 V, 100 V, 0r 1800W/2.6 Ohms.
- Processing built in: native 96 kHz DSP with FIR Drive up to 1025 taps.
- Networked audio: Dante / OCA over OMNEO with fallback for redundant routing.
- Watches the system: load monitoring and pilot-tone supervision on every line.
- Efficient by design: Class D output with ecoRAIL power management to cut running cost.
- ghostPOWER keeps DSP and network running to bridged mainspower switching in mission critical systems
Specifications
Overview & Features
- Configuration
4-channel
Acoustic Performance
- Frequency Response
20 Hz to 20 kHz (±0.5 dB)
- THD+N
< 0.05 %
- Crosstalk between channels (dBA)
< -80 dB
Power & Amplification
- Total Output Power*
5.000 W
- Bridged Output Power 4 Ω
2600 W