C1300FDi DSP power amplifier, install
C1300FDI
DSP DRIVE FOR THE INSTALL.
A 2 x 650 W install amplifier with onboard FIR drive, built to tune a fixed system and forget it.
C1300FDi DSP power amplifier, install
A 2-channel install DSP power amplifier rated 2 x 650 W, with integrated FIR Drive speaker processing, controlled in SONICUE, Euroblock connections.
Set the system once and let it hold. The C1300FDi pairs a 2 x 650 W Class-AB output stage with full FIR-capable DSP — output delay, a 31-band graphic EQ and PEQ per channel, and load-impedance monitoring — so a permanent install is dialed in tight from day one. Direct-drive 70 V/100 V operation feeds distributed lines without a transformer, and Phoenix connectors keep the wiring clean. Retail, hospitality, house of worship — the processing lives in the box, and the room just sounds right.
Key features
Tune it precisely
FIR filters, 31-band GEQ, and PEQ per channel onboard.
Drive distributed lines
direct-drive 70 V/100 V output, no transformer needed.
Protect the system
load-impedance monitoring plus full audio and thermal limiters.
Wire it clean
Phoenix connectors and a 19-inch, 2 RU install chassis.
Set and selectable
remote power and preset-select inputs for fixed installs.
Runs cool
front-to-rear three-stage fans, rated for +5°C to +40°C ambient.
Two-channel power amplifiers
L Series and C Series Amplifiers
Complete the System
Where this unit fits, and what it pairs with.
Features
The install version of the L platform. The C1300FDi delivers 2 x 650 W into 4 ohm with fully integrated FIR Drive, sets up and supervises in SONICUE (USB),connects on Euroblock, with GPIO for remote power and preset control. It runs low-impedance loads only. Three-stage front-to-rear fans and a full protection suite keep it running in the rack. Two rack units. Retail, hospitality, corporate, houses of worship, and fixed installs that want touring-grade processing built in.
- Install power: 650 W per channel into 4 ohm with integrated FIR Drive processing.
- Low-impedance operation for 2/4/8 ohm speaker systems.
- Set up in SONICUE (USB):levels, EQ, speaker settings with FIR filters, PEQ, delay, and limiters.
- Install-ready connections: Euroblock in/out and GPIO for remote power and preset select.
- Reliable in the rack: full protection suite with 3-stage front-to-rear cooling.
Specifications
Overview & Features
- Configuration
2-channel
Acoustic Performance
- Frequency Response
10 Hz to 21 kHz (±1 dB)
- THD+N
< 0.05 %
- Crosstalk between channels (dBA)
< -80 dB
- Signal-to-Noise Ratio
>104 dB
Power & Amplification
- Total Output Power*
1300 W